Attached to Project— Reseau Internet et Baies

Task Type	Maintenance
Category	Tout le réseau
Status	CLOSED
Percent Complete

Details b. After the image is copied to the supervisor engine, access configuration mode and set the boot
variable for the ACE and the image. For example, to access configuration mode and set the boot
variable if the ACE is in slot 3, enter:
Router# config t
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#boot device module 3 disk0:c6ace-t1k9-mz.A2_1.bin
Device BOOT variable = disk0:c6ace-t1k9-mz.A2_1.bin
Warning: Device list is not verified
Router#
From the ACE, perform the following steps:
a. Boot the ACE from the image on the supervisor engine by using the boot eobc command.
rommon 1> boot eobc: